Jump to content

Recommended Posts

Hi all,


I have a SPI interface, it has three modes to transfer the data out on IO[0:7]. In SPI standard there is just IO[0] is used. QPI mode, it uses IO[3:0] and In OPI mode, the whole IO are used. When driver receives a req from sequencer, it drives that req to the interface depending on modes. The interface sometimes goes with SPI, sometimes QPI or OPI. And I want to monitor the tx data, but I dont't know how to setup the monitor to sample the data corresponding to the mode that the driver has used. Are there ways to make monitor works in the same mode with the driver?


Thank you!


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...