Jump to content

Search the Community

Showing results for tags 'UVM Monitor'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • Accellera Systems Initiative
    • Information
    • Announcements
    • In the News
  • SystemC
    • SystemC Language
    • SystemC AMS (Analog/Mixed-Signal)
    • SystemC TLM (Transaction-level Modeling)
    • SystemC Verification (UVM-SystemC, SCV, CRAVE, FC4SC)
    • SystemC CCI (Configuration, Control & Inspection)
    • SystemC Datatypes
  • UVM (Universal Verification Methodology)
    • UVM (IEEE 1800.2) - Methodology and BCL Forum
    • UVM SystemVerilog Discussions
    • UVM Simulator Specific Issues
    • UVM Commercial Announcements
    • UVM (Pre-IEEE) Methodology and BCL Forum
  • Portable Stimulus
    • Portable Stimulus Discussion
    • Portable Stimulus 2.0 Public Review Feedback
  • IP Security
    • SA-EDI Standard Discussion
    • IP Security Assurance Whitepaper Discussion
  • IP-XACT
    • IP-XACT Discussion
  • SystemRDL
    • SystemRDL Discussion
  • IEEE 1735/IP Encryption
    • IEEE 1735/IP Encryption Discussion
  • Commercial Announcements
    • Announcements

Categories

  • SystemC
  • UVM
  • UCIS
  • IEEE 1735/IP Encryption

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Joined

  • Start

    End

Group

AIM

MSN

Website URL

ICQ

Yahoo

Jabber

Skype

Location

Interests

Biography

Location

Interests

Occupation

Company

Found 2 results

  1. Hongnhattl
    Hi all, I have a SPI interface, it has three modes to transfer the data out on IO[0:7]. In SPI standard there is just IO[0] is used. QPI mode, it uses IO[3:0] and In OPI mode, the whole IO are used. When driver receives a req from sequencer, it drives that req to the interface depending on modes. The interface sometimes goes with SPI, sometimes QPI or OPI. And I want to monitor the tx data, but I dont't know how to setup the monitor to sample the data corresponding to the mode that the driver has used. Are there ways to make monitor works in the same mode with the driver? Thank you!
  2. Hongnhattl
    Hi all, I have a SPI interface, it has three modes to transfer the data out on IO[0:7]. In SPI standard there is just IO[0] is used. QPI mode, it uses IO[3:0] and In OPI mode, the whole IO are used. When driver receives a req from sequencer, it drives that req to the interface depending on modes. The interface sometimes goes with SPI, sometimes QPI or OPI. And I want to monitor the tx data, but I dont't know how to setup the monitor to sample the data corresponding to the mode that the driver has used. Are there ways to make monitor works in the same mode with the driver? Thank you!
×
×
  • Create New...